💥FREE SHIPPING within the US on orders of $50 or more.


    Your Cart is Empty

    sPOD Touchscreen Mount with 20mm Ball


    (1x) sPOD Touchscreen Switch Panel mount with 20mm Ball
    (1x) sPOD Touchscreen Switch Panel mount with 20mm Ball
    (1x) 7cm Carbon Fiber + Kevlar Mounting Arm
    (1x) sPOD Touchscreen Switch Panel mount with 20mm Ball
    (1x) 1cm Aluminum Mounting Arm

    ✅ sPOD Touchscreen
    ❌ Does NOT fit sPOD HD Switch Panel
    ❌ Does NOT fit sPOD Mini6 Switch Panel

    Looking to secure your sPOD Touchscreen to your Bulletpoint Mounting Solutions dash mount? This is the device holder for you!

    This all-aluminum device holder is designed specifically to secure your sPOD Touchscreen. It features laser cut holes which allow the bolt and RJ45 jack on the back side of your sPOD unit to slide through. Finish securing it with the nut included with your sPOD Touchscreen.

    The full coverage mounting plate provides a superior level of stability and features RubiGrid®-inspired slots that complement your RubiGrid® dash mount.


    20mm Mounting System

    This sPOD device mount features an integrated 20mm mounting ball making it perfectly compatible with any of our mounting arms with 20mm socket ends (sold separately).

    That means if you already have one of our bases and mounting arms, this sPOD Touchscreen mount can be easily integrated to your existing setup.

    Low Profile Version

    Looking for a low profile installation? We offer another version of our sPOD Touchscreen mount but with a 20mm connector end - no mounting arm necessary!

    Looking to mount a different sPOD Device?

    We make mounts for other sPOD products. Check them out below:

    Important: no installation hardware is included. You must reuse the nut and bolt included with the sPOD Touchscreen.

      Customer Reviews

      Based on 1 review
      Rich Dennis
      sPod Touchscreen Mount

      Very good mount I just wish it was made with a Ethernet cable opening on both sides of the flag cut out at the bottom of the mount to allow the plate to be switched to the other side. The screw holes would need to be recessed on the other side as well.
      That is my only complaint, although minor it would facilitate a better positioning of the Touchscreen.